Introduction of steel machining parts

Views: 0     Author: Site Editor     Publish Time: 2021-11-18      Origin: Site

Inquire

facebook sharing button
twitter sharing button
line sharing button
wechat sharing button
linkedin sharing button
pinterest sharing button
whatsapp sharing button
sharethis sharing button
Introduction of steel machining parts

Due to the characteristics of steel machining parts, almost all industrial sectors require steel machining parts. Steel machining parts are used in medical equipment, aviation, military industry, industrial equipment, electronics, auto parts, commercial purposes, etc. Next, I will give you a brief introduction to steel machining parts. Here are some answers.


Here is that the content list:

l Advantages of steel machining parts.

l The main factor that steel machining parts are damaged.

l The load-bearing capacity of steel machining parts.


Advantages of steel machining parts.

First, the steel machining parts have high strength and high elastic modulus. Compared with concrete and wood, the ratio of density to yield strength of processed steel parts is relatively low. Therefore, under the same stress conditions, steel machining parts have small cross-sections and lightweight, which is convenient for transportation and installation and is suitable for spans. Large, high-height, heavy-duty structure.

Second, the steel machining parts have good toughness and plasticity. The steel machining parts have uniform materials and high structural reliability. The steel machining parts are suitable for withstanding impact and dynamic loads, and the processed steel parts have good seismic performance. The internal structure of the steel machining parts is uniform, close to an isotropic homogeneous body, and the actual working performance of the steel structure is more in line with the calculation theory. Therefore, the steel structure has high reliability.


The main factor that steel machining parts are damaged.

First, due to load changes, overdue service, and changes in specifications and regulations, the structural bearing capacity of steel machining parts is insufficient.

Second, due to various accidental deformations, distortions, disability, dents, etc., the steel machining parts cause warping and cracking of the steel machining parts. Third, the temperature difference causes deformation, cracking, and warping of steel workpieces. Fourth, corrosion caused by chemical substances and electrochemical corrosion leads to corrosion of steel machining parts. Fifth, errors in the design of steel machining parts, the production of steel machining parts, the construction of steel machining parts, and the illegal use and operation of steel machining parts.


The load-bearing capacity of steel machining parts.

The greater the force, the greater the deformation of the processed steel parts. However, when the force is too large, the steel machining parts will be broken or severe, and significant plastic deformation will occur, which will affect the normal use of the steel machining parts. To ensure the normal use of steel machining parts, each steel processed part is required to have sufficient load-bearing capacity, also known as load-bearing capacity. The size of the load-bearing capacity is mainly measured by the sufficient strength, rigidity, and stability of the steel machining parts. The strength of steel machining parts refers to the ability of steel machining parts to resist damage. The rigidity of the steel workpiece refers to the ability of the steel workpiece to resist deformation. If the steel machining parts undergo excessive deformation after being stressed, it cannot be used normally even if it has not been damaged. Therefore, the steel machining parts must have sufficient rigidity, that is, rigidity failure is not allowed to occur. The stability of steel machining parts refers to the ability of steel machining parts to maintain the original equilibrium form under the action of external force.


If you are interested in steel machining parts, you can come to consult. Our official website is http://www.jstindustry.com/.



Kunshan JST Industry Co., Ltd is a professional manufacturer of CNC machining parts, which were applied to the field of medical, aerospace & aviation, electronics, security & safety, industrial equipment and automotive.

Copyright © 2020 Kunshan JST Industry Co., Ltd

CONTACT US

   86-18915758793

   86-512-55260690

   info@jstindustry.com

   info_282418

   Carrolgu

   86-18915758793

 

PRODUCTS

GET IN TOUCH