Kunshan JST Industry Co., Ltd.
Home > News & Blog

Common Workpiece Defects and Causes in CNC Turning

Bend: 

1.The weight of the material and its own bending. It should be treated by straightening and hot province.

2.The workpiece clamping is not good, tailstock and the center hole is tight.

3.The improper selection of the geometric parameters and the cutting parameters of the CNC Turning, result to cutting force is too large. You can reduce the cutting depth and increase feed number.

4.Hot deformation is produced in cutting. Cooling lubricants should be used.

5.The distance between the tip and the support block is too large. It should not exceed 2mm.

Surface of CNC Turned Component is rough:

1.The vibration of the turning.

2.Improper selection of material with the support block of the tool, bad contact with the workpiece and friction.

3.The improper selection of the geometric parameters of the tool.

CNC Turned Component


23

Dec, 2017
Your Questions and Comments are Important to Us.

Fill in the Following Form, or Reach Us by Phone or E-mail.

Contact Us
Get in Touch
  • E-mail: info@jstindustry.com
  • Skype: info_282418
  • Tel: +86 512 5526 0690
  • Mob: +86 189 1575 8793
  • Fax: +86 512 5526 0691
  • Add:No. 1168 South Renmin Road, Kunshan, Jiangsu Province, 215300 China
Follow Us

Copyright © Kunshan JST Industry Co., Ltd.
All Rights Reserved  

Technical Support:

Privacy Policy

sitemap
info_282418